SVF Series
Manufacturer: BJM Pumps
Non-clog electric submersible pumps for sludge, sewage, trash & industrial waste. The SVF Series pumps are equipped with Vortex impellers, undoubtedly the best non-clog impellers ever invented for the handling of mud, raw sewage, viscous liquids, rags, wood chips and other solids. They pass solid up to 90% of pump outlet diameter.
• Longer power cord – Standard 50ft. high temperature power cord on pumps.
• 304 stainless steel motor housing – Superior abrasion resistance will not wear out like aluminum motor housings when pumping sandy water.
• Three seal motor protection – Motor is protected by double mechanical seals. Lower seal made of silicon carbide/silicon carbide and upper seal is made of carbon/ceramic. An additional lip seal has been installed above the impeller to help prevent abrasives such as dirt, silt or sand from entering into the seal chamber.
• Winding protection and (NEMA) Class R motor insulation with a thermal cut out switch that will allow the stator to have a winding temperature of up to 300 degrees F (150 C), superior to pumps with Class A and B insulation.
• Hardened cast iron stands up to rough handling and pumping sandy water unlike pumps with soft resin impellers or plastic exterior components.
• Specifications dependent on model & may change without notice
• All single phase Fahrenheit pumps are supplied with a NEMA 4X control box including pump start components, Seal Minder relay, motor thermal sensor connections and (1) High Temperature wide angle float switch with 20’ cable. These single-phase controls meet UL 508A and cUL CSA-22.2 requirements.
• 304 stainless steel motor housing – Superior abrasion resistance will not wear out like aluminum motor housings when pumping sandy water.
• Three seal motor protection – Motor is protected by double mechanical seals. Lower seal made of silicon carbide/silicon carbide and upper seal is made of carbon/ceramic. An additional lip seal has been installed above the impeller to help prevent abrasives such as dirt, silt or sand from entering into the seal chamber.
• Winding protection and (NEMA) Class R motor insulation with a thermal cut out switch that will allow the stator to have a winding temperature of up to 300 degrees F (150 C), superior to pumps with Class A and B insulation.
• Hardened cast iron stands up to rough handling and pumping sandy water unlike pumps with soft resin impellers or plastic exterior components.
• Specifications dependent on model & may change without notice
• All single phase Fahrenheit pumps are supplied with a NEMA 4X control box including pump start components, Seal Minder relay, motor thermal sensor connections and (1) High Temperature wide angle float switch with 20’ cable. These single-phase controls meet UL 508A and cUL CSA-22.2 requirements.